[Code of Federal Regulations]
[Title 29, Volume 9]
[Revised as of July 1, 2005]
From the U.S. Government Printing Office via GPO Access
[CITE: 29CFR1952.7]

[Page 20]
 
                             TITLE 29--LABOR
 
CHAPTER XVII--OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT 
                          OF LABOR (CONTINUED)
 
PART 1952_APPROVED STATE PLANS FOR ENFORCEMENT OF STATE STANDARDS
--Table of Contents
 
               Subpart A_General Provisions and Conditions
 
Sec. 1952.7  Product standards.

    (a) Under section 18(c)(2) of the Act, a State plan must not include 
standards for products which are distributed or used in interstate 
commerce which are different from Federal standards for such products 
unless such standards are required by compelling local conditions and do 
not unduly burden interstate commerce. In Sec. 1902.3(c)(2) of this 
chapter this is interpreted as not being applicable to customized 
products, or parts not normally available on the open market, or to the 
optional parts, or additions to products which are ordinarily available 
with such optional parts, or additions.
    (b) In situations where section 18(c)(2) is considered applicable, 
and provision is made for the adoption of product standards, the 
requirements of section 18(c)(2), as they relate to undue burden on 
interstate commerce, shall be treated as a condition subsequent in light 
of the facts and circumstances which may be involved.