[Code of Federal Regulations] [Title 40, Volume 29] [Revised as of July 1, 2005] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR433.15] [Page 273-274] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 433_METAL FINISHING POINT SOURCE CATEGORY--Table of Contents Subpart A_Metal Finishing Subcategory Sec. 433.15 Pretreatment standards for existing sources (PSES). (a) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subpart that introduces pollutants into a publicly owned treatment works must comply with 40 CFR part 403 and achieve the following [[Page 274]] pretreatment standards for existing sources (PSES): PSES for All Plants Except Job Shops and Independent Printed Circuit Board Manufacturers ------------------------------------------------------------------------ Monthly Maximum for average Pollutant or pollutant property any 1 day shall not exceed ------------------------------------------------------------------------ Milligrams per liter (mg/ l) --------------- Cadmium (T)................................. 0.69 0.26 Chromium (T)................................ 2.77 1.71 Copper (T).................................. 3.38 2.07 Lead (T).................................... 0.69 0.43 Nickel (T).................................. 3.98 2.38 Silver (T).................................. 0.43 0.24 Zinc (T).................................... 2.61 1.48 Cyanide (T)................................. 1.20 0.65 TTO......................................... 2.13 ............ ------------------------------------------------------------------------ (b) Alternatively, for industrial facilities with cyanide treatment, upon agreement between a source subject to those limits and the pollution control authority. The following amenable cyanide limit may apply in place of the total cyanide limit specified in paragraph (a) of this section: ------------------------------------------------------------------------ Monthly Maximum for average Pollutant or pollutant property any 1 day shall not exceed ------------------------------------------------------------------------ Milligrams per liter (mg/ l) --------------- Cyanide (A)................................. 0.86 0.32 ------------------------------------------------------------------------ (c) No user introducing wastewater pollutants into a publicly owned treatment works under the provisions of this subpart shall augment the use of process wastewater as a partial or total substitute for adequate treatment to achieve compliance with this standard. (d) An existing source submitting a certification in lieu of monitoring pursuant to Sec. 433.12 (a) and (b) of this regulation must implement the toxic organic management plan approved by the control authority. (e) An existing source subject to this subpart shall comply with a daily maximum pretreatment standard for TTO of 4.57 mg/l. (f) Compliance with the provisions of paragraph (c), (d), and (e) of this section shall be achieved as soon as possible, but not later than June 30, 1984, however metal finishing facilities which are also covered by part 420 (iron and steel) need not comply before July 10, 1985. Compliance with the provisions of paragraphs (a) and (b) of this section shall be achieved as soon as possible, but not later than February 15, 1986. [48 FR 32485, July 15, 1983, as amended at 48 FR 41410, Sept. 15, 1983; 48 FR 43682, Sept. 26, 1983]