[Code of Federal Regulations] [Title 40, Volume 29] [Revised as of July 1, 2005] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR467.36] [Page 638-639] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 467_ALUMINUM FORMING POINT SOURCE CATEGORY--Table of Contents Subpart C_Extrusion Subcategory Sec. 467.36 Pretreatment standards for new sources. (a) Except as provided in 40 CFR 403.7, any new source subject to this subpart which introduces pollutants into a publicly owned treatment works must comply with 40 CFR part 403 and achieve the following pretreatment standards for new sources. (b) There shall be no discharge allowance for wastewater pollutants from the degassing operation. (c) The mass of wastewater pollutants from the core and ancillary operations except those identified in paragraph (b) introduced into a POTW shall not exceed the values set forth below: Subpart C Core ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million off-lbs) of extruded -------------- Chromium...................................... 0.13 0.05 Cyanide....................................... 0.07 0.03 Zinc.......................................... 0.35 0.15 TTO........................................... 0.24 ........... Oil and grease (alternate monitoring 3.40 3.40 parameter)................................... ------------------------------------------------------------------------ Subpart C Extrusion Press Leakage ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million off-lbs) of hard alloy aluminum extruded -------------- Chromium...................................... 0.11 0.05 Cyanide....................................... 0.06 0.03 Zinc.......................................... 0.31 0.13 TTO........................................... 0.21 ........... Oil and grease (alternate monitoring 2.98 2.98 parameter)................................... ------------------------------------------------------------------------ Subpart C Direct Chill Casting Contact Cooling Water ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million off-lbs) of aluminum cast -------------- Chromium...................................... 0.49 0.20 Cyanide....................................... 0.27 0.11 Zinc.......................................... 1.36 0.56 TTO........................................... 0.92 ........... Oil and grease (alternate monitoring 13.29 13.29 parameter)................................... ------------------------------------------------------------------------ Subpart C Press Heat Treatment Contact Cooling Water ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million off-lbs) of aluminum quenched -------------- Chromium...................................... 0.76 0.31 Cyanide....................................... 0.41 0.17 Zinc.......................................... 2.08 0.86 TTO........................................... 1.41 ........... Oil and grease (alternate monitoring 20.37 20.37 parameter)................................... ------------------------------------------------------------------------ Subpart C Solution Heat Treatment Contact Cooling Water ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million- off-lbs) of aluminum quenched -------------- Chromium...................................... 0.76 0.31 Cyanide....................................... 0.41 0.17 Zinc.......................................... 2.08 0.86 TTO........................................... 1.41 ........... Oil and grease (alternate monitoring 20.37 20.37 parameter)................................... ------------------------------------------------------------------------ [[Page 639]] Subpart C Cleaning or Etching Bath ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million- off-lbs) of aluminum cleaned or etched -------------- Chromium...................................... 0.067 0.027 Cyanide....................................... 0.036 0.015 Zinc.......................................... 0.183 0.075 TTO........................................... 0.124 ........... Oil and grease (alternate monitoring 1.79 1.79 parameter)................................... ------------------------------------------------------------------------ Subpart C Cleaning or Etching Rinse ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million- off-lbs) of aluminum cleaned or etched -------------- Chromium...................................... 0.52 0.21 Cyanide....................................... 0.28 0.11 Zinc.......................................... 1.42 0.59 TTO........................................... 0.96 ........... Oil and grease (alternate monitoring 13.91 13.91 parameter)................................... ------------------------------------------------------------------------ Subpart C Cleaning or Etching Scrubber Liquor ------------------------------------------------------------------------ PSNS ------------------------- Pollutant or pollutant property Maximum for Maximum for monthly any 1 day average ------------------------------------------------------------------------ mg/off-kg (lb/million- off-lbs) of aluminum cleaned or etched -------------- Chromium...................................... 0.72 0.29 Cyanide....................................... 0.39 0.16 Zinc.......................................... 1.97 0.81 TTO........................................... 1.34 ........... Oil and grease (alternate monitoring 19.33 19.33 parameter)................................... ------------------------------------------------------------------------ [48 FR 49149, Oct. 24, 1983; 49 FR 11632, 11633, and 11634, Mar. 27, 1984]