[Code of Federal Regulations]

[Title 40, Volume 29]

[Revised as of July 1, 2005]

From the U.S. Government Printing Office via GPO Access

[CITE: 40CFR469.25]



[Page 679]

 

                   TITLE 40--PROTECTION OF ENVIRONMENT

 

         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)

 

PART 469_ELECTRICAL AND ELECTRONIC COMPONENTS POINT SOURCE CATEGORY

--Table of Contents

 

                Subpart B_Electronic Crystals Subcategory

 

Sec. 469.25  Effluent limitations representing the degree of effluent 



reduction attainable by the application of the best available technology 

economically 

          achievable (BAT).



    Except as provided in 40 CFR 125.30 through 32, any existing point 

source subject to this subpart must achieve the following effluent 

limitations representing the degree of effluent reduction attainable by 

the application of the best available technology economically available 

(BAT):



         Subpart B--Electronic Crystals BAT Effluent Limitations

------------------------------------------------------------------------

                                                             Average of

                                                            daily values

       Pollutant or pollutant property         Maximum for     for 30

                                                any 1 day    consecutive

                                                                days

------------------------------------------------------------------------

                                               Milligrams per liter (mg/

                                                          l)

                                             ---------------

TTO \1\.....................................          1.37      (\3\)

Arsenic\2\..................................          2.09          0.83

Fluoride....................................         32.0          17.4

------------------------------------------------------------------------

\1\ Total toxic organics.

\2\ The arsenic limitation only applies to manufacturers of gallium or

  indium arsenide crystals.

\3\ Not applicable.