[Code of Federal Regulations] [Title 48, Volume 1] [Revised as of October 1, 2005] From the U.S. Government Printing Office via GPO Access [CITE: 48CFR9.204] [Page 154-155] TITLE 48--FEDERAL ACQUISITION REGULATIONS SYSTEM CHAPTER 1--FEDERAL ACQUISITION REGULATION PART 9_CONTRACTOR QUALIFICATIONS--Table of Contents Subpart 9.2_Qualifications Requirements Sec. 9.204 Responsibilities for establishment of a qualification requirement. The responsibilities of agency activities that establish qualification requirements include the following: (a) Arranging publicity for the qualification requirements. If active competition on anticipated future qualification requirements is likely to be fewer than two manufacturers or the products of two manufacturers, the activity responsible for establishment of the qualification requirements must-- (1) Periodically furnish through the Governmentwide point of entry (GPE) a notice seeking additional sources or products for qualification unless the contracting officer determines that such publication would compromise the national security. (2) Bear the cost of conducting the specified testing and evaluation (excluding the costs associated with producing the item or establishing the production, quality control, or other system to be tested and evaluated) for a small business concern or a product manufactured by a small business concern which has met the standards specified for qualification and which could reasonably be expected to compete for a contract for that requirement. However, such costs may be borne only if it is determined in accordance with agency procedures that such additional qualified sources or products are likely to result in cost savings from increased competition for future requirements sufficient to amortize the costs incurred by the agency within a reasonable period of time, considering the duration and dollar value of anticipated future requirements. A prospective contractor requesting the United States to bear testing and evaluation costs must certify as to its status as a small business concern under section 3 of the Small Business Act in order to receive further consideration. (b) Qualifying products that meet specification requirements. (c) Listing manufacturers and suppliers whose products are qualified in accordance with agency procedures. (d) Furnishing QPL's, OML's, or QBL's or the qualification requirements themselves to prospective offerors and the public upon request (see 9.202(a)(2)(i) above). (e) Clarifying, as necessary, qualification requirements. (f) In appropriate cases, when requested by the contracting officer, providing concurrence in a decision not to [[Page 155]] enforce a qualification requirement for a solicitation. (g) Withdrawing or omitting qualification of a listed product, manufacturer or offeror, as necessary. (h) Advising persons furnished any list of products, manufacturers or offerors meeting a qualification requirement and suppliers whose products are on any such list that-- (1) The list does not constitute endorsement of the product, manufacturer, or other source by the Government; (2) The products or sources listed have been qualified under the latest applicable specification; (3) The list may be amended without notice; (4) The listing of a product or source does not release the supplier from compliance with the specification; and (5) Use of the list for advertising or publicity is permitted. However, it must not be stated or implied that a particular product or source is the only product or source of that type qualified, or that the Government in any way recommends or endorses the products or the sources listed. (i) Reexamining a qualified product or manufacturer when-- (1) The manufacturer has modified its product, or changed the material or the processing sufficiently so that the validity of previous qualification is questionable; (2) The requirements in the specification have been amended or revised sufficiently to affect the character of the product; or (3) It is otherwise necessary to determine that the quality of the product is maintained in conformance with the specification. [50 FR 35476, Aug. 30, 1985, as amended at 66 FR 27413, May 16, 2001; 68 FR 56679, Oct. 1, 2003]