[Code of Federal Regulations]

[Title 49, Volume 6]

[Revised as of October 1, 2005]

From the U.S. Government Printing Office via GPO Access

[CITE: 49CFR571.5]



[Page 211-212]

 

                        TITLE 49--TRANSPORTATION

 

                            OF TRANSPORTATION

 

PART 571_FEDERAL MOTOR VEHICLE SAFETY STANDARDS--Table of Contents

 

                            Subpart A_General

 

Sec. 571.5  Matter incorporated by reference.



    (a) Incorporation. There are hereby incorporated, by reference, into 

this part, all materials referred to in any standard in subpart B of 

this part that are not set forth in full in the standard. These 

materials are thereby made part of this regulation. The Director of the 

Federal Register has approved the materials incorporated by reference. 

For materials subject to change, only the specific version approved by 

the Director of the Federal Register and specified in the standard are 

incorporated. A notice of any change in these materials will be 

published in the Federal Register. As a convenience to the reader, the 

materials incorporated by reference are listed in the Finding Aid Table 

found at the end of this volume of the Code of Federal Regulations.

    (b) Availability. The materials incorporated by reference, other 

than acts of Congress and matter published elsewhere in the Federal 

Register, are available as follows:

    (1) Standards of the Society of Automotive Engineers (SAE). They are 

published by the Society of Automotive Engineers, Inc. Information and 

copies may be obtained by writing to: Society of Automotive Engineers, 

Inc., 400 Commonwealth Drive, Warrendale, Pennsylvania 15096.

    (2) Standards of the American Society for Testing and Materials 

(ASTM). They are published by the American Society for Testing and 

Materials. Information and copies may be obtained by writing to: ASTM 

International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 

19428-2959.

    (3) Standards of the American National Standards Institute (ANSI). 

They are published by the American National Standards Institute. 

Information and copies may be obtained by writing to: RESNA, 1700 North 

Moore St., Suite 1540, Arlington, VA 22209-1903.

    (4) Data on the Weight Height and Selected Body Dimensions of 

Adults. They are published by the National Center for Health Statistics, 

Centers for Disease Control (CDC). Information and copies may be 

obtained on the CDC web site at http://www.cdc.gov/nchs or by writing to 

National Division for Health Statistics, Division of Data Services, 

Hyattsville, MD 20782-2003.

    (5) Test Methods of the American Association of Textile Chemists and 

Colorists (AATCC). They are published by the American Association of 

Textile Chemists and Colorists. Information and copies may be obtained 

by writing to: AATCC, 1 Davis Dr., P.O. Box 12215, Research Triangle 

Park, NC 27709.

    (6) Test methods of the Illuminating Engineering Society of North 

America (IES). They are published by the Illuminating Engineering 

Society of North America.



[[Page 212]]



Information and copies may be obtained by writing to: IES, 120 Wall St., 

7th Floor, New York, NY 10005.

    (7) Standards of Suppliers of Advanced Composite Materials 

Association (SACMA). They are published by Suppliers of Advanced 

Composite Materials Association. Information and copies may be obtained 

by writing to: Suppliers of Advanced Composite Materials Association, 

1600 Wilson Blvd., Suite 1008, Arlington, VA 22209.

    (8) Standards of the American Society of Mechanical Engineers 

(ASME). They are published by the American Society of Mechanical 

Engineers. Information and copies may be obtained by writing to: ASME, 

22 Law Drive, P.O. Box 2900, Fairfield, NJ 07007-2900.

    (9) Regulations of the United Nations Economic Commission for Europe 

(ECE). They are published by the United Nations. Information and copies 

may be obtained by writing to: United Nations, Conference Services 

Division, Distribution and Sales Section, Office C.115-1, Palais des 

Nations, CH-1211, Geneva 10, Switzerland. Copies of Regulations also are 

available on the ECE internet web site: www.unece.org/trans/main/wp29/

wp29regs.html.

    (10) Child Restraint Systems Seat Assembly Drawing Package. Copies 

may be obtained by contacting: Leet-Melbrook, 18810 Woodfield Road, 

Gaithersburg, MD, 20879, telephone (301) 670-0090.

    (11) All of the above materials, as well as any other materials 

incorporated by reference, are available for inspection and copying at 

the Office of Vehicle Safety Standards, National Highway Traffic Safety 

Administration, 400 Seventh Street, SW., Washington, DC 20590. The 

materials are also available for inspection and copying at the National 

Archives and Records Administration (NARA). For information on the 

availability of this material at NARA, call 202-741-6030, or go to: 

http://www.archives.gov/federal--register/code--of--federal--

regulations/ibr--locations.html.



[33 FR 19704, Dec. 25, 1968. Redesignated at 35 FR 5118, Mar. 26, 1970, 

and amended at 35 FR 5120, Mar. 26, 1970; 36 FR 1148, Jan. 23, 1971; 41 

FR 52880, Dec. 2, 1976; 41 FR 56812, Dec. 30, 1976; 47 FR 7254, Feb. 18, 

1982; 48 FR 30141, June 30, 1983; 54 FR 20083, May 9, 1989; 59 FR 49021, 

Sept. 26, 1994; 60 FR 37843, July 24, 1995; 64 FR 45898, Aug. 23, 1999; 

67 FR 77193, Dec. 17, 2002; 68 FR 37654, June 24, 2003]