[Code of Federal Regulations]

[Title 14, Volume 1]

[Revised as of January 1, 2006]

From the U.S. Government Printing Office via GPO Access

[CITE: 14CFR21.123]



[Page 136]

 

                     TITLE 14--AERONAUTICS AND SPACE

 

CHAPTER I--FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION

 

PART 21_CERTIFICATION PROCEDURES FOR PRODUCTS AND PARTS--Table of Contents

 

            Subpart F_Production Under Type Certificate Only

 

Sec. 21.123  Production under type certificate.



    Each manufacturer of a product being manufactured under a type 

certificate only shall--

    (a) Make each product available for inspection by the Administrator;

    (b) Maintain at the place of manufacture the technical data and 

drawings necessary for the Administrator to determine whether the 

product and its parts conform to the type design;

    (c) Except as otherwise authorized by the Aircraft Certification 

Directorate Manager for the geographic area which the manufacturer is 

located, for products manufactured more than 6 months after the date of 

issue of the type certificate, establish and maintain an approved 

production inspection system that insures that each product conforms to 

the type design and is in condition for safe operation; and

    (d) Upon the establishment of the approved production inspection 

system (as required by paragraph (c) of this section) submit to the 

Administrator a manual that describes that system and the means for 

making the determinations required by Sec. 21.125(b).



[Doc. No. 5085, 29 FR 14568, Oct. 24, 1964, as amended by Amdt. 21-34, 

35 FR 13008, Aug. 15, 1970; Amdt. 21-51, 45 FR 60170, Sept. 11, 1980; 

Amdt. 21-67, 54 FR 39291, Sept. 25, 1989]