[Code of Federal Regulations] [Title 14, Volume 1] [Revised as of January 1, 2006] From the U.S. Government Printing Office via GPO Access [CITE: 14CFR21.33] [Page 127] TITLE 14--AERONAUTICS AND SPACE CHAPTER I--FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION PART 21_CERTIFICATION PROCEDURES FOR PRODUCTS AND PARTS--Table of Contents Subpart B_Type Certificates Sec. 21.33 Inspection and tests. (a) Each applicant must allow the Administrator to make any inspection and any flight and ground test necessary to determine compliance with the applicable requirements of the Federal Aviation Regulations. However, unless otherwise authorized by the Administrator-- (1) No aircraft, aircraft engine, propeller, or part thereof may be presented to the Administrator for test unless compliance with paragraphs (b)(2) through (b)(4) of this section has been shown for that aircraft, aircraft engine, propeller, or part thereof; and (2) No change may be made to an aircraft, aircraft engine, propeller, or part thereof between the time that compliance with paragraphs (b)(2) through (b)(4) of this section is shown for that aircraft, aircraft engine, propeller, or part thereof and the time that it is presented to the Administrator for test. (b) Each applicant must make all inspections and tests necessary to determine-- (1) Compliance with the applicable airworthiness, aircraft noise, fuel venting, and exhaust emission requirements; (2) That materials and products conform to the specifications in the type design; (3) That parts of the products conform to the drawings in the type design; and (4) That the manufacturing processes, construction and assembly conform to those specified in the type design. [Doc. No. 5085, 29 FR 14564, Oct. 24, 1964, as amended by Amdt. 21-17, 32 FR 14926, Oct. 28, 1967; Amdt. 21-27, 34 FR 18363, Nov. 18, 1969; Amdt. 21-44, 41 FR 55463, Dec. 20, 1976; Amdt. 21-68, 55 FR 32860, Aug. 10, 1990; Amdt. 21-68, 55 FR 32860, Aug. 10, 1990]