[Code of Federal Regulations]

[Title 14, Volume 1]

[Revised as of January 1, 2006]

From the U.S. Government Printing Office via GPO Access

[CITE: 14CFR45.15]



[Page 903]

 

                     TITLE 14--AERONAUTICS AND SPACE

 

CHAPTER I--FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION

 

PART 45_IDENTIFICATION AND REGISTRATION MARKING--Table of Contents

 

        Subpart B_Identification of Aircraft and Related Products

 

Sec. 45.15  Replacement and modification parts.



    (a) Except as provided in paragraph (b) of this section, each person 

who produces a replacement or modification part under a Parts 

Manufacturer Approval issued under Sec. 21.303 of this chapter shall 

permanently and legibly mark the part with--

    (1) The letters ``FAA-PMA'';

    (2) The name, trademark, or symbol of the holder of the Parts 

Manufacturer Approval;

    (3) The part number; and

    (4) The name and model designation of each type certificated product 

on which the part is eligible for installation.

    (b) If the Administrator finds that a part is too small or that it 

is otherwise impractical to mark a part with any of the information 

required by paragraph (a) of this section, a tag attached to the part or 

its container must include the information that could not be marked on 

the part. If the marking required by paragraph (a)(4) of this section is 

so extensive that to mark it on a tag is impractical, the tag attached 

to the part or the container may refer to a specific readily available 

manual or catalog for part eligibility information.



[Amdt. 45-8, 37 FR 10660, May 26, 1972, as amended by Amdt. 45-14, 47 FR 

13315, Mar. 29, 1982]