[Code of Federal Regulations]
[Title 16, Volume 1]
[Revised as of January 1, 2006]
From the U.S. Government Printing Office via GPO Access
[CITE: 16CFR259.2]

[Page 179-180]
 
                     TITLE 16--COMMERCIAL PRACTICES
 
                   CHAPTER I--FEDERAL TRADE COMMISSION
 
PART 259_GUIDE CONCERNING FUEL ECONOMY ADVERTISING FOR NEW AUTOMOBILES
--Table of Contents
 
Sec. 259.2  Advertising disclosures.

    (a) No manufacturer or dealer shall make any express or implied 
representation in advertising concerning the fuel economy of any new 
automobile \1\ unless such representation is accompanied by the 
following clear and conspicuous disclosures:
---------------------------------------------------------------------------

    \1\ The Commission will regard as an express or implied fuel economy 
representation one which a reasonable consumer, upon considering the 
representation in the context of the entire advertisement, would 
understand as referring to the fuel economy performance of the vehicle 
or vehicles advertised.
---------------------------------------------------------------------------

    (1) If the advertisement makes:
    (i) Both a city and a highway fuel economy representation, both the 
``estimated city mpg'' and the ``estimated highway mpg'' of such new 
automobile,\2\ must be disclosed;
---------------------------------------------------------------------------

    \2\ For purposes of Sec. 259.2(a), the ``estimated city mpg'' and 
the ``estimated highway mpg'' must be those applicable to the specific 
nameplate being advertised. Fuel economy estimates assigned to ``unique 
nameplates'' (see 40 CFR 600.207-86(a)(2)) apply only to such unique car 
lines. For example, if a manufacturer has a model named the ``XZA'' that 
has fuel economy estimates assigned to it and a derivative model named 
the ``Econo-XZA'' that has separate, higher fuel economy estimates 
assigned to it, these higher numbers assigned to the ``Econo-XZA'' 
cannot be used in advertisements for the ``XZA.''
---------------------------------------------------------------------------

    (ii) A representation regarding only city or only highway fuel 
economy, only the corresponding EPA estimate must be disclosed; \3\
---------------------------------------------------------------------------

    \3\ For example, if the representation clearly refers only to 
highway fuel economy, only the ``estimated highway mpg'' need be 
disclosed.
---------------------------------------------------------------------------

    (iii) A general fuel economy claim without reference to either city 
or highway, or if the representation refers to any combined fuel economy 
number, the ``estimated city mpg'' must be disclosed; \4\ and
---------------------------------------------------------------------------

    \4\ Nothing in this section should be construed as prohibiting 
disclosure of both the city and highway estimates.
---------------------------------------------------------------------------

    (2) That the U.S. Environmental Protection Agency is the source of 
the ``estimated city mpg'' and ``estimated highway mpg'' and that the 
numbers are estimates.\5\
---------------------------------------------------------------------------

    \5\ The Commission will regard the following as the minimum 
disclosure necessary to comply with Sec. 259.2(a)(2), regardless of the 
media in which the advertisement appears: ``EPA estimate(s).''
    For television, if the estimated mpg appears in the video, the 
disclosure must appear in the video; if the estimated mpg is audio, the 
disclosure must be audio.
---------------------------------------------------------------------------

    (b) If an advertisement for a new automobile cites:
    (1) The ``estimated in-use fuel economy range,'' the advertisement 
must state with equal prominence both the upper and lower number of the 
range, an explanation of the meaning of the numbers (i.e., city mpg 
range or highway mpg range or both), and that the U.S. Environmental 
Protection Agency is the source of the figures.
    (2) The ``range of estimated fuel economy values for the class of 
new automobiles'' as a basis for comparing the fuel economy of two or 
more automobiles, such comparison must be

[[Page 180]]

made to the same type of range (i.e., city or highway).\6\
---------------------------------------------------------------------------

    \6\ For example, an advertisement could not state that ``according 
to EPA estimates new automobiles in this class get as little as X mpg 
(citing a figure from the city range) while EPA estimates that this 
automobile gets X + mpg (citing the EPA highway estimates or a number 
from the EPA estimated in-use fuel economy highway range for the 
automobile).
---------------------------------------------------------------------------

    (c) Fuel economy estimates derived from a non-EPA test may be 
disclosed provided that:
    (1) The advertisement also discloses the ``estimated city mpg'' and/
or the ``estimated highway mpg,'' as required by Sec. 259.2(a), and the 
disclosure required by Sec. 259.2(a), and gives the ``estimated city 
mpg'' and/or the ``estimated highway mpg'' figure(s) substantially more 
prominence than any other estimate; \7\ provided, however, for radio and 
television advertisements in which any other estimate is used only in 
the audio, equal prominence must be given the ``estimated city mpg'' 
and/or the ``estimated highway mpg'' figure(s); \8\
---------------------------------------------------------------------------

    \7\ The Commission will regard the following as constituting 
``substantially more prominence:''
    For television only: If the estimated city and/or highway mpg and 
any other mileage estimate(s) appear only in the visual portion, the 
estimated city and/or highway mpg must appear in numbers twice as large 
as those used for any other estimate, and must remain on the screen at 
least as long as any other estimate. If the estimated city and highway 
mpg appear in the audio portion, visual broadcast of any other estimate 
must be accompanied by the simultaneous, at least equally prominent, 
visual broadcast of the estimated city and/or highway mpg. Each visual 
estimated city and highway mpg must be broadcast against a solid color 
background that contrasts easily with the color used for the numbers 
when viewed on both color and black and white television.
    For print only: The estimated city and/or highway mpg must appear in 
clearly legible type at least twice as large as that used for any other 
estimate. Alternatively, if the estimated city and highway mpg appear in 
type of the same size as such other estimate, they must be clearly 
legible and conspicuously circled. The estimated city and highway mpg 
must appear against a solid color, contrasting background. They may not 
appear in a footnote unless all references to fuel economy appear in a 
footnote.
    \8\ The Commission will regard the following as constituting equal 
prominence. For radio and television when any other estimate is used in 
the audio: The estimated city and/or highway mpg must be stated, either 
before or after each disclosure of such other estimate at least as 
audibly as such other estimate.
---------------------------------------------------------------------------

    (2) The source of the non-EPA test is clearly and conspicuously 
identified;
    (3) The driving conditions and variables simulated by the test which 
differ from those used to measure the ``estimated city mpg'' and/or the 
``estimated highway mpg,'' and which result in a change in fuel economy, 
are clearly and conspicuously disclosed.\9\ Such conditions and 
variables may include, but are not limited to, road or dynamometer test, 
average speed, range of speed, hot or cold start, and temperature; and
---------------------------------------------------------------------------

    \9\ For dynamometer tests any difference between the EPA and non-EPA 
tests must be disclosed. For in-use tests, the Commission realizes that 
it is impossible to duplicate the EPA test conditions, and that in-use 
tests may be designed to simulate a particular driving situation. It 
must be clear from the context of the advertisement what driving 
situation is being simulated (e.g., cold weather driving, highway 
driving, heavy load conditions). Furthermore, any driving or vehicle 
condition must be disclosed if it is significantly different from that 
which an appreciable number of consumers (whose driving condition is 
being simulated) would expect to encounter.
---------------------------------------------------------------------------

    (4) The advertisement clearly and conspicuously discloses any 
distinctions in ``vehicle configuration'' and other equipment affecting 
mileage performance (e.g., design or equipment differences which 
distinguish subconfigurations as defined by EPA) between the automobiles 
tested in the non-EPA test and the EPA tests.

[60 FR 56231, Nov. 8, 1995]