[Code of Federal Regulations]

[Title 33, Volume 3]

[Revised as of July 1, 2006]

From the U.S. Government Printing Office via GPO Access

[CITE: 33CFR401.48]



[Page 673]

 

                TITLE 33--NAVIGATION AND NAVIGABLE WATERS

 

CHAPTER IV--SAINT LAWRENCE SEAWAY DEVELOPMENT CORPORATION, DEPARTMENT OF 

                             TRANSPORTATION

 

PART 401_SEAWAY REGULATIONS AND RULES--Table of Contents

 

                          Subpart A_Regulations

 

Sec.  401.48  Turning basins.



    No vessel shall be turned about in any canal, except:

    (a) With permission from the vessel traffic controller; and

    (b) At the locations set out in the table to this section.



                                  Table



    1. South Shore Canal:

    (a) Turning Basin No. 1--Opposite Brossard.

    (b) Turning Basin No. 2--Between Lock 7 and the Guard Gate Cut for 

vessels up to 180 m in overall length.

    2. Welland Canal:

    (a) Turning Basin No. 1--Opposite St. Catharines Wharf for vessels 

up to 107 m in overall length.

    (b) Turning Basin No. 2--Between Lock 7 and the Guard Gate Cut for 

vessels up to 180 m in overall length.

    (c) Turning Basin No. 3--Immediately south of Port Robinson (Mile 

13).

    (d) Turning Basin No. 4--North of Lock No. 8 for vessels up to 170 m 

in overall length.

    (e) For vessels up to 80 m in overall length.

    (1) North end of Wharf No. 1,

    (2) Tie-up wall above Lock 1,

    (3) Tie-up wall below Lock 2,

    (4) Wharf No. 9,

    (5) Between the southerly extremities of Wharves 18-2 and 18-3.



(68 Stat. 93-96, 33 U.S.C. 981-990, as amended and secs. 4, 5, 6, 7, 8, 

12 and 13 of sec. 2 of Pub. L. 95-474, 92 Stat. 1471)



[39 FR 10900, Mar. 22, 1974, as amended at 47 FR 51123, Nov. 12, 1982; 

48 FR 20691, May 9, 1983; 49 FR 30936, Aug. 2, 1984]