[Code of Federal Regulations] [Title 40, Volume 31] [Revised as of July 1, 2006] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR1048.125] [Page 557-558] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 1048_CONTROL OF EMISSIONS FROM NEW, LARGE NONROAD SPARK-IGNITION ENGINES--Table of Contents Subpart B_Emission Standards and Related Requirements Sec. 1048.125 What maintenance instructions must I give to buyers? Give the ultimate purchaser of each new nonroad engine written instructions for properly maintaining and using the engine, including the emission-control system. The maintenance instructions also apply to service accumulation on your emission-data engines, as described in 40 CFR part 1065. (a) Critical emission-related maintenance. Critical emission-related maintenance includes any adjustment, cleaning, repair, or replacement of critical emission-related components. This may also include additional emission-related maintenance that you determine is critical if we approve it in advance. You may schedule critical emission-related maintenance on these components if you meet the following conditions: (1) You demonstrate that the maintenance is reasonably likely to be done at the recommended intervals on in-use engines. We will accept scheduled maintenance as reasonably likely to occur if you satisfy any of the following conditions: (i) You present data showing that, if a lack of maintenance increases emissions, it also unacceptably degrades the engine's performance. (ii) You present survey data showing that at least 80 percent of engines in the field get the maintenance you specify at the recommended intervals. (iii) You provide the maintenance free of charge and clearly say so in maintenance instructions for the customer. (iv) You otherwise show us that the maintenance is reasonably likely to be done at the recommended intervals. (2) You may not schedule critical emission-related maintenance more frequently than the following minimum intervals, except as specified in paragraphs (a)(3), (b) and (c) of this section: (i) For catalysts, fuel injectors, electronic control units, superchargers, and turbochargers: The useful life of the engine family. (ii) For gaseous fuel-system components (cleaning without disassembly only) and oxygen sensors: 2,500 hours. (3) If your engine family has an alternate useful life under Sec. 1048.101(g) that is shorter than the period specified in paragraph (a)(2)(ii) of this section, you may not schedule critical emission- related maintenance more frequently than the alternate useful life, except as specified in paragraph (c) of this section. (b) Recommended additional maintenance. You may recommend any additional amount of maintenance on the components listed in paragraph (a) of this section, as long as you state clearly that these maintenance steps are not necessary to keep the emission-related warranty valid. If operators do the maintenance specified in paragraph (a) of this section, but not the recommended additional maintenance, this does not allow you to disqualify those engines from in-use testing or deny a warranty claim. Do not take these maintenance steps during service accumulation on your emission-data engines. (c) Special maintenance. You may specify more frequent maintenance to address problems related to special situations, such as substandard fuel or atypical engine operation. For example, you may specify more frequent cleaning of fuel system components for engines you have reason to believe will be using fuel that causes substantially [[Page 558]] more engine performance problems than commercial fuels of the same type that are generally available across the United States. You must clearly state that this additional maintenance is associated with the special situation you are addressing. (d) Noncritical emission-related maintenance. You may schedule any amount of emission-related inspection or maintenance that is not covered by paragraph (a) of this section, as long as you state in the owners manual that these steps are not necessary to keep the emission-related warranty valid. If operators fail to do this maintenance, this does not allow you to disqualify those engines from in-use testing or deny a warranty claim. Do not take these inspection or maintenance steps during service accumulation on your emission-data engines. (e) Maintenance that is not emission-related. For maintenance unrelated to emission controls, you may schedule any amount of inspection or maintenance. You may also take these inspection or maintenance steps during service accumulation on your emission-data engines, as long as they are reasonable and technologically necessary. This might include adding engine oil, changing air, fuel, or oil filters, servicing engine-cooling systems, and adjusting idle speed, governor, engine bolt torque, valve lash, or injector lash. You may perform this nonemission-related maintenance on emission-data engines at the least frequent intervals that you recommend to the ultimate purchaser (but not the intervals recommended for severe service). (f) Source of parts and repairs. State clearly on the first page of your written maintenance instructions that a repair shop or person of the owner's choosing may maintain, replace, or repair emission-control devices and systems. Your instructions may not require components or service identified by brand, trade, or corporate name. Also, do not directly or indirectly condition your warranty on a requirement that the engine be serviced by your franchised dealers or any other service establishments with which you have a commercial relationship. You may disregard the requirements in this paragraph (f) if you do one of two things: (1) Provide a component or service without charge under the purchase agreement. (2) Get us to waive this prohibition in the public's interest by convincing us the engine will work properly only with the identified component or service. (g) Payment for scheduled maintenance. Owners are responsible for properly maintaining their engines. This generally includes paying for scheduled maintenance. However, manufacturers must pay for scheduled maintenance during the useful life if it meets all the following criteria: (1) Each affected component was not in general use on similar engines before January 1, 2004. (2) The primary function of each affected component is to reduce emissions. (3) The cost of the scheduled maintenance is more than 2 percent of the price of the engine. (4) Failure to perform the maintenance would not cause clear problems that would significantly degrade the engine's performance. (h) Owners manual. Explain the owner's responsibility for proper maintenance in the owners manual. [70 FR 40468, July 13, 2005]