[Code of Federal Regulations]

[Title 40, Volume 31]

[Revised as of July 1, 2006]

From the U.S. Government Printing Office via GPO Access

[CITE: 40CFR1065.120]



[Page 686]

 

                   TITLE 40--PROTECTION OF ENVIRONMENT

 

         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)

 

PART 1065_ENGINE-TESTING PROCEDURES--Table of Contents

 

                   Subpart B_Equipment Specifications

 

Sec.  1065.120  Fuel properties and fuel temperature and pressure.



    (a) Use fuels as specified in subpart H of this part.

    (b) If the engine manufacturer specifies fuel temperature and 

pressure tolerances and the location where they are to be measured, then 

measure the fuel temperature and pressure at the specified location to 

show that you are within these tolerances throughout testing.

    (c) If the engine manufacturer does not specify fuel temperature and 

pressure tolerances, use good engineering judgment to set and control 

fuel temperature and pressure in a way that represents typical in-use 

fuel temperatures and pressures.