[Code of Federal Regulations] [Title 40, Volume 28] [Revised as of July 1, 2006] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR411.25] [Page 194] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 411_CEMENT MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart B_Leaching Subcategory Sec. 411.25 Standards of performance for new sources. The following standards of performance establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a new source subject to the provisions of this subpart: ------------------------------------------------------------------------ Effluent limitations (maximum Effluent characteristic for any 1 day) ------------------------------------------------------------------------ Metric units (kg/kkg of dust leached) --------------------------------- TSS................................... 0.4. Temperature (heat).................... Not to exceed 3 [deg]C rise above inlet temperature. pH.................................... Within the range 6.0 to 9.0. --------------------------------- English units (lb/1,000 lb of dust leached) --------------------------------- TSS................................... 0.4. Temperature (heat).................... Not to exceed 3 [deg]C rise above inlet temperature. pH.................................... Within the range 6.0 to 9.0. ------------------------------------------------------------------------