[Code of Federal Regulations]

[Title 40, Volume 12]

[Revised as of July 1, 2006]

From the U.S. Government Printing Office via GPO Access

[CITE: 40CFR63.1443]



[Page 27]

 

                   TITLE 40--PROTECTION OF ENVIRONMENT

 

         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)

 

PART 63_NATIONAL EMISSION STANDARDS FOR HAZARDOUS AIR POLLUTANTS FOR 

SOURCE CATEGORIES--Table of Contents

 

Subpart QQQ_National Emission Standards for Hazardous Air Pollutants for 

                         Primary Copper Smelting

 

Sec.  63.1443  When do I have to comply with this subpart?



    (a) If you have an existing affected source, you must comply with 

each emission limitation, work practice standard, and operation and 

maintenance requirement in this subpart that applies to you no later 

than June 13, 2005.

    (b) If you have a new affected source and its initial startup date 

is on or before June 12, 2002, you must comply with each emission 

limitation, work practice standard, and operation and maintenance 

requirement in this subpart that applies to you by June 12, 2002.

    (c) If you have a new affected source and its initial startup date 

is after June 12, 2002, you must comply with each emission limitation, 

work practice standard, and operation and maintenance requirement in 

this subpart that applies to you upon initial startup.

    (d) If your primary copper smelter is an area source that becomes a 

major source of HAP, the compliance dates listed in paragraphs (d)(1) 

and (2) of this section apply to you.

    (1) Any portion of the existing primary copper smelter that is a new 

affected source or a new reconstructed source must be in compliance with 

this subpart upon startup.

    (2) All other parts of the primary copper smelter must be in 

compliance with this subpart no later than 3 years after it becomes a 

major source.

    (e) You must meet the notification and schedule requirements in 

Sec.  63.1454. Several of these notifications must be submitted before 

the compliance date for your affected source.



            Emission Limitations and Work Practice Standards