[Code of Federal Regulations]
[Title 40, Volume 30]
[Revised as of July 1, 2006]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR761.45]

[Page 633-634]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 761_POLYCHLORINATED BIPHENYLS (PCBs) MANUFACTURING, PROCESSING, 
DISTRIBUTION IN COMMERCE, AND USE PROHIBITIONS--Table of Contents
 
                 Subpart C_Marking of PCBs and PCB Items
 
Sec.  761.45  Marking formats.

    The following formats shall be used for marking:
    (a) Large PCB Mark--ML. Mark ML shall be as shown in 
Figure 1, letters and striping on a white or yellow background and shall 
be sufficiently durable to equal or exceed the life (including storage 
for disposal) of the PCB Article, PCB Equipment, or PCB Container. The 
size of the mark shall be at least 15.25 cm (6 inches) on each side. If 
the PCB Article or PCB Equipment is too small to accommodate this size, 
the mark may be reduced in size proportionately down to a minimum of 5 
cm (2 inches) on each side.
    (b) Small PCB Mark--Ms. Mark Ms shall be as shown in 
Figure 2, letters and striping on a white or yellow background, and 
shall be sufficiently durable to equal or exceed the life (including 
storage for disposal) of the PCB Article, PCB Equipment, or PCB 
Container. The mark shall be a rectangle 2.5 by 5 cm (1 inch by 2 
inches). If the PCB Article or PCB Equipment is too small to accommodate 
this size, the mark may be reduced in size proportionately down to a 
minimum of 1 by 2 cm (.4 by .8 inches).

[[Page 634]]

[GRAPHIC] [TIFF OMITTED] TC01AP92.000


[44 FR 31542, May 31, 1979. Redesignated at 47 FR 19527, May 6, 1982]