[Code of Federal Regulations]

[Title 47, Volume 1]

[Revised as of October 1, 2006]

From the U.S. Government Printing Office via GPO Access

[CITE: 47CFR2.933]



[Page 702]

 

                       TITLE 47--TELECOMMUNICATION

 

              CHAPTER I--FEDERAL COMMUNICATIONS COMMISSION

 

PART 2_FREQUENCY ALLOCATIONS AND RADIO TREATY MATTERS; GENERAL RULES AND 

REGULATIONS--Table of Contents

 

              Subpart J_Equipment Authorization Procedures

 

Sec.  2.933  Change in identification of equipment.



    (a) A new application for equipment authorization shall be filed 

whenever there is a change in the FCC Identifier for the equipment with 

or without a change in design, circuitry or construction. However, a 

change in the model/type number or trade name performed in accordance 

with the provisions in Sec.  2.924 of this chapter is not considered to 

be a change in identification and does not require additional 

authorization from the Commission.

    (b) An application filed pursuant to paragraph (a) of this section 

where no change in design, circuitry or construction is involved, need 

not be accompanied by a resubmission of equipment or measurement or test 

data customarily required with a new application, unless specifically 

requested by the Commission. In lieu thereof, the applicant shall attach 

a statement setting out:

    (1) The original identification used on the equipment prior to the 

change in identification.

    (2) The date of the original grant of the equipment authorization.

    (3) How the equipment bearing the modified identification differs 

from the original equipment.

    (4) Whether the original test results continue to be representative 

of and applicable to the equipment bearing the changed identification.

    (5) The photographs required by Sec.  2.1033(b)(7) or Sec.  

2.1033(c)(12) showing the exterior appearance of the equipment, 

including the operating controls available to the user and the 

identification label. Photographs of the construction, the component 

placement on the chassis, and the chassis assembly are not required to 

be submitted unless specifically requested by the Commission.

    (c) If the change in the FCC Identifier also involves a change in 

design or circuitry which falls outside the purview of a permissive 

change described in Sec.  2.1043, a complete application shall be filed 

pursuant to Sec.  2.911.



[63 FR 36598, July 7, 1998]