[Code of Federal Regulations] [Title 49, Volume 6] [Revised as of October 1, 2006] From the U.S. Government Printing Office via GPO Access [CITE: 49CFR451.1] [Page 10-11] TITLE 49--TRANSPORTATION CHAPTER IV--COAST GUARD, DEPARTMENT OF HOMELAND SECURITY PART 451_TESTING AND APPROVAL OF CONTAINERS--Table of Contents Subpart A_Approval of Existing Containers Sec. 451.1 Application for approval. (a) Any owner of an existing container may apply for approval to the Commandant (G-MSO), U.S. Coast Guard, Washington, DC 20593 or to any Approval Authority. (b) Each application must include the following for each container: (1) Date and place of manufacture. (2) Manufacturer's identification number, if available. (3) Maximum operating gross weight capacity. [[Page 11]] (4) Allowable stacking weight for 1.8G (1.8xGross weight in kilograms or pounds). Note: This value is the total load the container is designed to support when subjected to a vertical acceleration of 1.8G. (5) A statement that the owner possesses documentary evidence that: (i) Container of this type has been safely used in marine or inland transport for a period of at least two years; or (ii) The container was manufactured to a design type which had been tested and found to comply with the technical conditions set out in Annex II to the convention with the exception of those technical conditions relating to the end-wall and side-wall strength tests; or (iii) The container was constructed to standards that were equivalent to the technical conditions set out in Annex II to the convention with the exception of those technical conditions relating to end-wall and side-wall strength tests. (6) A certification by the owner, or, if the owner is a corporation, partnership or unincorporated association, by a person authorized to make such statements for the organization, that the information provided in the application is true and correct. [45 FR 37214, June 2, 1980, as amended at 47 FR 50496, Nov. 8, 1982; 69 FR 58352, Sept. 30, 2004]