[Code of Federal Regulations]
[Title 49, Volume 6]
[Revised as of October 1, 2006]
From the U.S. Government Printing Office via GPO Access
[CITE: 49CFR572.15]

[Page 908-909]
 
                        TITLE 49--TRANSPORTATION
 
                   CHAPTER V--NATIONAL HIGHWAY TRAFFIC
                    SAFETY ADMINISTRATION, DEPARTMENT
                            OF TRANSPORTATION
 
PART 572_ANTHROPOMORPHIC TEST DEVICES--Table of Contents
 
                       Subpart C_3-Year-Old Child
 
Sec.  572.15  General description.

    Source: 44 FR 76530, Dec. 27, 1979, unless otherwise noted.


    (a) The dummy consists of the component assemblies specified in 
drawing SA 103C 001, which are described in their entirety by means of 
approximately 122 drawings and specifications

[[Page 909]]

and an Operation and Maintenance Manual, dated May 28, 1976. The 
drawings and specifications are grouped by component assemblies under 
the following thirteen headings:

SA 103C 010 Head Assembly
SA 103C 020 Neck Assembly
SA 103C 030 Torso Assembly
SA 103C 041 Upper Arm Assembly Left
SA 103C 042 Upper Arm Assembly Right
SA 103C 051 Forearm Hand Assembly Left
SA 103C 052 Forearm Hand Assembly Right
SA 103C 061Upper Leg Assembly Left
SA 103C 062 Upper Leg Assembly Right
SA 103C 071 Lower Leg Assembly Left
SA 103C 072 Lower Leg Assembly Right
SA 103C 081 Foot Assembly left
SA 103C 082 Foot Assembly Right.

    (b) The drawings, specifications, and operation and maintenance 
manual referred to in this regulation that are not set forth in full are 
hereby incorporated in this part by reference. These materials are 
thereby made part of this regulation. The Director of the Federal 
Register has approved the materials incorporated by reference. For 
materials subject to change, only the specific version approved by the 
Director of the Federal Register and specified in the regulation are 
incorporated. A notice of any change will be published in the Federal 
Register. As a convenience to the reader, the materials incorporated by 
reference are listed in the Finding Aid Table found at the end of this 
volume of the Code of Federal Regulations.
    (c) The materials incorporated by reference are available for 
examination in Docket 78-09, Room 5109, Docket Section, National Highway 
Traffic Safety Administration, 400 Seventh Street SW., Washington, DC 
20590. Copies may be obtained from Rowley-Scher Reprographics, Inc., 
1216 K Street NW., Washington, DC 20005 ((202) 628-6667). The materials 
are also on file in the reference library of the Office of the Federal 
Register, National Archives and Records Administration, Washington, DC.
    (d) Adjacent segments are joined in a manner such that throughout 
the range of motion and also under simulated crash-impact conditions 
there is no contact between metallic elements except for contacts that 
exist under static conditions.
    (e) The structural properties of the dummy are such that the dummy 
conforms to this part in every respect both before and after being used 
in vehicle tests specified in Standard No. 213 of this chapter (Sec.  
571.213).
    (f) The patterns of all cast and molded parts for reproduction of 
the molds needed in manufacturing of the dummies can be obtained on a 
loan basis by manufacturers of the testes dummies, or others if need is 
shown, from: Office of Vehicle Safety Standards, National Highway 
Traffic Safety Administration, 400 Seventh Street SW., Washington, DC 
20590.

[50 FR 25423, June 19, 1985]