[Code of Federal Regulations]
[Title 49, Volume 6]
[Revised as of October 1, 2006]
From the U.S. Government Printing Office via GPO Access
[CITE: 49CFR572.5]

[Page 897-898]
 
                        TITLE 49--TRANSPORTATION
 
                   CHAPTER V--NATIONAL HIGHWAY TRAFFIC
                    SAFETY ADMINISTRATION, DEPARTMENT
                            OF TRANSPORTATION
 
PART 572_ANTHROPOMORPHIC TEST DEVICES--Table of Contents
 
                     Subpart B_50th Percentile Male
 
Sec.  572.5  General description.


    (a) The dummy consists of the component assemblies specified in 
Figure 1, which are described in their entirety by means of 
approximately 250 drawings and specifications that are grouped by 
component assemblies under the following nine headings:

SA 150 M070--Right arm assembly
SA 150 M071--Left arm assembly
SA 150 M050--Lumbar spine assembly
SA 150 M060--Pelvis and abdomen assembly
SA 150 M080--Right leg assembly
SA 150 M081--Left leg assembly
SA 150 M010--Head assembly
SA 150 M020--Neck assembly
SA 150 M030--Shoulder-thorax assembly.

    (b) The drawings and specifications referred to in this regulation 
that are not set forth in full are hereby incorporated in this part by 
reference. These materials are thereby made part of this regulation. The 
Director of the Federal Register has approved the materials incorporated 
by reference. For materials subject to change, only the specific version 
approved by the Director of the Federal Register and specified in the 
regulation are incorporated. A notice of any change will be published in 
the Federal Register. As a convenience to the reader, the materials 
incorporated by reference are listed in the Finding Aid Table found at 
the end of this volume of the Code of Federal Regulations.
    (c) The materials incorporated by reference are available for 
examination in Docket 73-08, Docket Section, National Highway Traffic 
Safety Administration, Room 5109, 400 Seventh Street SW., Washington, 
DC, 20590. Copies may be obtained from Rowley-Scher Reprographics, Inc., 
1216 K Street NW., Washington, DC 20005 ((202) 628-6667). The drawings 
and specifications are also on file in the reference library of the 
Office of the Federal Register, National Archives and Records 
Administration, Washington, DC.
    (d) Adjacent segments are joined in a manner such that throughout 
the range of motion and also under crash impact conditions there is no 
contact between metallic elements except for contacts that exist under 
static conditions.
    (e) The structural properties of the dummy are such that the dummy 
conforms to this part in every respect both before and after being used 
in vehicle

[[Page 898]]

tests specified in Standard No. 208 of this chapter (571.208).
    (f) A specimen of the dummy is available for surface measurements 
and access can be arranged by contacting: Office of Vehicle Safety 
Standards, National Highway Traffic Safety Administration, 400 Seventh 
Street, SW., Washington, DC 20590.

[50 FR 25423, June 19, 1985]