[Code of Federal Regulations]
[Title 14, Volume 1]
[Revised as of January 1, 2007]
From the U.S. Government Printing Office via GPO Access
[CITE: 14CFR21.6]

[Page 124]
 
                     TITLE 14--AERONAUTICS AND SPACE
 
CHAPTER I--FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION
 
PART 21_CERTIFICATION PROCEDURES FOR PRODUCTS AND PARTS--Table of 
Contents
 
                            Subpart A_General
 
Sec.  21.6  Manufacture of new aircraft, aircraft engines, and propellers.

    (a) Except as specified in paragraphs (b) and (c) of this section, 
no person may manufacture a new aircraft, aircraft engine, or propeller 
based on a type certificate unless the person--
    (1) Is the holder of the type certificate or has a licensing 
agreement from the holder of the type certificate to manufacture the 
product; and
    (2) Meets the requirements of subpart F or G of this part.
    (b) A person may manufacture one new aircraft based on a type 
certificate without meeting the requirements of paragraph (a) of this 
section if that person can provide evidence acceptable to the FAA that 
the manufacture of the aircraft by that person began before August 5, 
2004.
    (c) The requirements of this section do not apply to--
    (1) New aircraft imported under the provisions of Sec.  Sec.  
21.183(c), 21.184(b), or 21.185(c); and
    (2) New aircraft engines or propellers imported under the provisions 
of Sec.  21.500.

[Doc. No. FAA-2003-14825, 71 FR 52258, Sept. 1, 2006]