[Code of Federal Regulations] [Title 16, Volume 2] [Revised as of January 1, 2007] From the U.S. Government Printing Office via GPO Access [CITE: 16CFR1203.3] [Page 216] TITLE 16--COMMERCIAL PRACTICES CHAPTER II--CONSUMER PRODUCT SAFETY COMMISSION PART 1203_SAFETY STANDARD FOR BICYCLE HELMETS--Table of Contents Subpart A_The Standard Sec. 1203.3 Referenced documents. (a) The following documents are incorporated by reference in this standard. (1) Draft ISO/DIS Standard 6220-1983--Headforms for Use in the Testing of Protective Helmets.\1\ --------------------------------------------------------------------------- \1\ Although the draft ISO/DIS 6220-1983 standard was never adopted as an international standard, it has become a consensus national standard because all recent major voluntary standards used in the United States for testing bicycle helmets establish their headform dimensions by referring to the draft ISO standard. --------------------------------------------------------------------------- (2) SAE Recommended Practice SAE J211 OCT88, Instrumentation for Impact Tests. (b) This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies of the standards may be obtained as follows. Copies of the draft ISO/DIS Standard 6220-1983 are available from American National Standards Institute, 11 W. 42nd St., 13th Floor, New York, NY 10036. Copies of the SAE Recommended Practice SAE J211 OCT88, Instrumentation for Impact Tests, are available from Society of Automotive Engineers, 400 Commonwealth Dr., Warrendale, PA 15096. Copies may be inspected at the Office of the Secretary, Consumer Product Safety Commission, 4330 East-West Highway, Bethesda, Maryland 20814, or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http:// www.archives.gov/federal--register/code--of--federal--regulations/ibr-- locations.html.