[Code of Federal Regulations]
[Title 16, Volume 2]
[Revised as of January 1, 2007]
From the U.S. Government Printing Office via GPO Access
[CITE: 16CFR1510.3]

[Page 551]
 
                     TITLE 16--COMMERCIAL PRACTICES
 
             CHAPTER II--CONSUMER PRODUCT SAFETY COMMISSION
 
PART 1510_REQUIREMENTS FOR RATTLES--Table of Contents
 
Sec.  1510.3  Requirements.

    No portion of a rattle, when tested in accordance with the procedure 
of Sec.  1510.4 below, shall be capable of entering and penetrating to 
the full depth of a cavity in a test fixture with dimensions shown in 
figure 1. (In determining these dimensions for compliance purposes, the 
English measurements shall be used. Metric equivalents are included for 
convenience.) Rattles shall meet this requirement both before and after 
performing the use and abuse tests of Sec.  1500.51 of this chapter 
(excluding the bite and flexure tests of paragraphs (c) and (d)).