[Code of Federal Regulations]
[Title 40, Volume 31]
[Revised as of July 1, 2007]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR1039.510]

[Page 510]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 1039_CONTROL OF EMISSIONS FROM NEW AND IN-USE NONROAD 
COMPRESSION-IGNITION ENGINES--Table of Contents
 
                        Subpart F_Test Procedures
 
Sec.  1039.510  Which duty cycles do I use for transient testing?

    (a) Measure emissions by testing the engine on a dynamometer with 
one of the following transient duty cycles to determine whether it meets 
the transient emission standards in Sec.  1039.101(a):
    (1) For variable-speed engines, use the transient duty cycle 
described in Appendix VI of this part.
    (2) [Reserved]
    (b) The transient test sequence consists of an initial run through 
the transient duty cycle from a cold start, 20 minutes with no engine 
operation, then a final run through the same transient duty cycle. Start 
sampling emissions immediately after you start the engine. Calculate the 
official transient emission result from the following equation:

Official transient emission result = 0.05 x cold-start emission rate + 
0.95 x hot-start emission rate.


[69 FR 39213, June 29, 2004, as amended at 70 FR 40463, July 13, 2005]