[Code of Federal Regulations]
[Title 40, Volume 31]
[Revised as of July 1, 2007]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR1051.130]

[Page 624-625]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 1051_CONTROL OF EMISSIONS FROM RECREATIONAL ENGINES
AND VEHICLES--Table of Contents
 
          Subpart B_Emission Standards and Related Requirements
 
Sec.  1051.130  What installation instructions must I give to vehicle manufacturers?

    (a) If you sell an engine for someone else to install in a piece of 
nonroad equipment, give the engine installer instructions for installing 
it consistent with the requirements of this part. Include all 
information necessary to ensure that an engine will be installed in its 
certified configuration.
    (b) Make sure these instructions have the following information:
    (1) Include the heading: ``Emission-related installation 
instructions''.
    (2) State: ``Failing to follow these instructions when installing a 
certified engine in a piece of nonroad equipment violates federal law 
(40 CFR 1068.105(b)), subject to fines or other penalties as described 
in the Clean Air Act.''.
    (3) Describe the instructions needed to properly install the exhaust 
system and any other components. Include instructions consistent with 
the requirements of Sec.  1051.205(r).
    (4) Describe the steps needed to comply with the evaporative 
emission standards in Sec.  1051.110.
    (5) Describe any limits on the range of applications needed to 
ensure that the engine operates consistently with your application for 
certification. For example, if your engines are certified only to the 
snowmobile standards, tell vehicle manufacturers not to install the 
engines in other vehicles.
    (6) Describe any other instructions to make sure the installed 
engine will operate according to design specifications in your 
application for certification. This may include, for example, 
instructions for installing aftertreatment devices when installing the 
engines.
    (7) State: ``If you install the engine in a way that makes the 
engine's emission contro information label hard to read during normal 
engine maintenance, you must place a duplicate label on the vehicle, as 
described in 40 CFR 1068.105.''.

[[Page 625]]

    (c) You do not need installation instructions for engines you 
install in your own vehicles.
    (d) Provide instructions in writing or in an equivalent format. For 
example, you may post instructions on a publicly available Web site for 
downloading or printing. If you do not provide the instructions in 
writing, explain in your application for certification how you will 
ensure that each installer is informed of the installation requirements.

[70 FR 40490, July 13, 2005]