[Code of Federal Regulations]
[Title 40, Volume 31]
[Revised as of July 1, 2007]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR1065.120]

[Page 687]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 1065_ENGINE-TESTING PROCEDURES--Table of Contents
 
                   Subpart B_Equipment Specifications
 
Sec.  1065.120  Fuel properties and fuel temperature and pressure.

    (a) Use fuels as specified in subpart H of this part.
    (b) If the engine manufacturer specifies fuel temperature and 
pressure tolerances and the location where they are to be measured, then 
measure the fuel temperature and pressure at the specified location to 
show that you are within these tolerances throughout testing.
    (c) If the engine manufacturer does not specify fuel temperature and 
pressure tolerances, use good engineering judgment to set and control 
fuel temperature and pressure in a way that represents typical in-use 
fuel temperatures and pressures.