[Code of Federal Regulations] [Title 40, Volume 31] [Revised as of July 1, 2007] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR1068.501] [Page 850-853] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 1068_GENERAL COMPLIANCE PROVISIONS FOR NONROAD PROGRAMS--Table of Contents Subpart F_Reporting Defects and Recalling Engines Sec. 1068.501 How do I report engine defects? This section addresses your responsibility to investigate and report emission-related defects in design, materials, or workmanship. The provisions of this section do not limit your liability under this part or the Clean Air Act. For example, selling an engine that does not conform to your application for certification is a violation of Sec. 1068.101(a)(1), independent of the requirements of this section. (a) General provisions. As an engine manufacturer, you must investigate in certain circumstances whether engines that have been introduced into commerce in the United States have incorrect, improperly installed, or otherwise defective emission-related components or systems. You must also send us reports as specified by this section. (1) This section addresses defects for any of the following emission-related components, or systems containing the following components: (i) Electronic control units, aftertreatment devices, fuel-metering components, EGR-system components, crankcase-ventilation valves, all components related to charge-air compression and cooling, and all sensors associated with any of these components. (ii) Any other component whose primary purpose is to reduce emissions. (iii) Any other component whose failure might increase emissions of any pollutant without significantly degrading engine performance. (2) The requirements of this section relate to defects in any of the components or systems identified in paragraph (a)(1) of this section if the defects might affect any of the parameters or specifications in Appendix II of this part or might otherwise affect an engine's emissions of any pollutant. (3) For the purposes of this section, defects do not include damage to emission-related components or systems (or maladjustment of parameters) caused by owners improperly maintaining or abusing their engines. (4) The requirements of this section do not apply to emission control information labels. Note however, that Sec. 1068.101(a)(1) prohibits the sale of engines without proper labels, which also applies to misprinted labels. (5) You must track the information specified in paragraph (b)(1) of this section. You must assess this data at least every three months to evaluate whether you exceed the thresholds specified in paragraphs (e) and (f) of this section. Where thresholds are based on a percentage of engines in the engine family, use actual sales figures for the whole model year when they become available. Use projected sales figures until the actual sales figures become available. You are not required to collect additional information other than that specified in paragraph (b)(1) of this section before reaching a threshold for an investigation specified in paragraph (e) of this section. (6) You may ask us to allow you to use alternate methods for tracking, investigating, reporting, and correcting emission-related defects. In your request, explain and demonstrate why you believe your alternate system will be at least as effective in the aggregate in tracking, identifying, investigating, evaluating, reporting, and correcting potential and actual emissions-related defects as the requirements in this section. In this case, provide all available data necessary to demonstrate why an alternate system is appropriate for your engines and how it will result in a system at least as effective as that required under this section. (7) If we determine that emission-related defects result in a substantial number of properly maintained and used engines not conforming to the regulations of this chapter during their useful life, we may order you to conduct a recall of your engines (see Sec. 1068.505). (8) Send all reports required by this section to the Designated Officer. (9) This section distinguishes between defects and possible defects. A possible defect exists anytime there is an indication that an emission-related component or system might have a defect, as described in paragraph (b)(1) of this section. (b) Investigation of possible defects. Investigate possible defects as follows: (1) If the number of engines that have a possible defect, as defined by this [[Page 851]] paragraph (b)(1), exceeds a threshold specified in paragraph (e) of this section, you must conduct an investigation to determine if an emission- related component or system is actually defective. You must classify an engine component or system as having a possible defect if any of the following sources of information shows there is a significant possibility that a defect exists: (i) A warranty claim is submitted for the component, whether this is under your emission-related warranty or any other warranty. (ii) Your quality-assurance procedures suggest that a defect may exist. (iii) You receive any other information for which good engineering judgment would indicate the component or system may be defective, such as information from dealers, field-service personnel, hotline complaints, or engine diagnostic systems. (2) If the number of shipped replacement parts for any individual component is high enough that good engineering judgment would indicate a significant possibility that a defect exists, you must conduct an investigation to determine if it is actually defective. Note that this paragraph (b)(2) does not require data-tracking or recording provisions related to shipment of replacement parts. (3) Your investigation must be prompt, thorough, consider all relevant information, follow accepted scientific and engineering principles, and be designed to obtain all the information specified in paragraph (d) of this section. (4) Your investigation needs to consider possible defects that occur only within the useful life period, or within five years after the end of the model year, whichever is longer. (5) You must continue your investigation until you are able to show that there is no emission-related defect or you obtain all the information specified for a defect report in paragraph (d) of this section. Send us an updated defect report anytime you have significant additional information. (6) If a component with a possible defect is used in additional engine families or model years, you must investigate whether the component may be defective when used in these additional engine families or model years, and include these results in any defect report you send under paragraph (c) of this section. (7) If your initial investigation concludes that the number of engines with a defect is fewer than any of the thresholds specified in paragraph (f) of this section, but other information later becomes available that may show that the number of engines with a defect exceeds a threshold, then you must resume your investigation. If you resume an investigation, you must include the information from the earlier investigation to determine whether to send a defect report. (c) Reporting defects. You must send us a defect report in either of the following cases: (1) Your investigation shows that the number of engines with a defect exceeds a threshold specified in paragraph (f) of this section. Send the defect report within 21 days after the date you identify this number of defective engines. See paragraph (h) of this section for reporting requirements that apply if the number of engines with a defect does not exceed any of the thresholds in paragraph (f) of this section. (2) You know there are emission-related defects for a component or system in a number of engines that exceeds a threshold specified in paragraph (f) of this section, regardless of how you obtain this information. Send the defect report within 21 days after you learn that the number of defects exceeds a threshold. (d) Contents of a defect report. Include the following information in a defect report: (1) Your corporate name and a person to contact regarding this defect. (2) A description of the defect, including a summary of any engineering analyses and associated data, if available. (3) A description of the engines that have the defect, including engine families, models, and range of production dates. (4) An estimate of the number and percentage of each class or category of affected engines that have the defect, [[Page 852]] and an explanation of how you determined this number. Describe any statistical methods you used under paragraph (g)(6) of this section. (5) An estimate of the defect's impact on emissions, with an explanation of how you calculated this estimate and a summary of any emission data demonstrating the impact of the defect, if available. (6) A description of your plan for addressing the defect or an explanation of your reasons for not believing the defects must be addressed. (e) Thresholds for conducting a defect investigation. You must begin a defect investigation based on the following number of engines that may have the defect: (1) For engines with maximum engine power at or below 560 kW: (i) For engine families with annual sales below 500 units: 50 or more engines. (ii) For engine families with annual sales from 500 to 50,000 units: more than 10.0 percent of the total number of engines in the engine family. (iii) For engine families with annual sales above 50,000 units: 5,000 or more engines. (2) For engines with maximum engine power greater than 560 kW: (i) For engine families with annual sales below 250 units: 25 or more engines. (ii) For engine families with annual sales at or above 250 units: more than 10.0 percent of the total number of engines in the engine family. (f) Thresholds for filing a defect report. You must send a defect report based on the following number of engines that have the defect: (1) For engines with maximum engine power at or below 560 kW: (i) For engine families with annual sales below 1,000 units: 20 or more engines. (ii) For engine families with annual sales from 1,000 to 50,000 units: more than 2.0 percent of the total number of engines in the engine family. (iii) For engine families with annual sales above 50,000 units: 1,000 or more engines. (2) For engines with maximum engine power greater than 560 kW: (i) For engine families with annual sales below 150 units: 10 or more engines. (ii) For engine families with annual sales from 150 to 750 units: 15 or more engines. (iii) For engine families with annual sales above 750 units: more than 2.0 percent of the total number of engines in the engine family. (g) How to count defects. (1) Track defects separately for each model year and engine family as much as possible. If information is not identifiable by model year or engine family, use good engineering judgment to evaluate whether you exceed a threshold in paragraph (e) or (f) of this section. Consider only your U.S.-directed production volume. (2) Within an engine family, track defects together for all components or systems that are the same in all material respects. If multiple companies separately supply a particular component or system, treat each company's component or system as unique. (3) If a possible defect is not attributed to any specific part of the engine, consider the complete engine a distinct component for evaluating whether you exceed a threshold in paragraph (e) of this section. (4) If you correct defects before they reach the ultimate purchaser as a result of your quality-assurance procedures, count these against the investigation thresholds in paragraph (e) of this section unless you routinely check every engine in the engine family. Do not count any corrected defects as actual defects under paragraph (f) of this section. (5) Use aggregated data from all the different sources identified in paragraph (b)(1) of this section to determine whether you exceed a threshold in paragraphs (e) and (f) of this section. (6) If information is readily available to conclude that the possible defects identified in paragraph (b)(1) of this section are actual defects, count these toward the reporting thresholds in paragraph (f) of this section. (7) During an investigation, use appropriate statistical methods to project defect rates for engines that you are not otherwise able to evaluate. [[Page 853]] For example, if 75 percent of the components replaced under warranty are available for evaluation, it would be appropriate to extrapolate known information on failure rates to the components that are unavailable for evaluation. Take steps as necessary to prevent bias in sampled data. Make adjusted calculations to take into account any bias that may remain. (h) Investigation reports. Once you trigger an investigation threshold under paragraph (e) of this section, you must report your progress and conclusions. In your reports, include the information specified in paragraph (d) of this section, or explain why the information is not relevant. Send us the following reports: (1) While you are investigating, send us mid-year and end-of-year reports to describe the methods you are using and the status of the investigation. Send these status reports no later than June 30 and December 31 of each year. (2) If you find that the number of components or systems with an emission-related defect exceeds a threshold specified in paragraph (f) of this section, send us a report describing your findings within 21 days after the date you reach this conclusion. (3) If you find that the number of components or systems with an emission-related defect does not exceed any of the thresholds specified in paragraph (f) of this section, send us a final report supporting this conclusion. For example, you may exclude warranty claims that resulted from misdiagnosis and you may exclude defects caused by improper maintenance, improper use, or misfueling. Send this report within 21 days after the date you reach this conclusion. (i) Future production. If you identify a design or manufacturing defect that prevents engines from meeting the requirements of this part, you must correct the defect as soon as possible for future production of engines in every family affected by the defect. This applies without regard to whether you are required to conduct a defect investigation or submit a defect report under this section. [69 FR 39270, June 29, 2004]