[Code of Federal Regulations] [Title 40, Volume 29] [Revised as of July 1, 2007] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR427.15] [Page 49-50] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 427_ASBESTOS MANUFACTURING POINT SOURCE CATEGORY --Table of Contents Subpart A_Asbestos-Cement Pipe Subcategory Sec. 427.15 Standards of performance for new sources. The following standards of performance establish the quantity or quality [[Page 50]] of pollutants or pollutant properties, controlled by this section, which may be discharged by a new source subject to the provisions of this subpart: ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed-- ------------------------------------------------------------------------ Metric units (kg/kkg of product) ----------------------------- TSS....................................... 0.57 0.19 pH........................................ (\1\) (\1\) ----------------------------- English units (lb/ton of product) ----------------------------- TSS....................................... 1.14 0.38 pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range 6.0 to 9.0.