[Code of Federal Regulations] [Title 40, Volume 29] [Revised as of July 1, 2007] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR428.15] [Page 63] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 428_RUBBER MANUFACTURING POINT SOURCE CATEGORY --Table of Contents Subpart A_Tire and Inner Tube Plants Subcategory Sec. 428.15 Standards of performance for new sources. The following standards of performance establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a new source subject to the provisions of this subpart: ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed-- ------------------------------------------------------------------------ Metric units (kg/kkg of raw material) ----------------------------- TSS....................................... 0.096 180.064 Oil and grease............................ 0.024 .016 pH........................................ (\1\) (\1\) ----------------------------- English units (lb/1,000 lb of raw material) ----------------------------- TSS....................................... 0.096 0.064 Oil and grease............................ 0.024 .016 pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range 6.0 to 9.0. [39 FR 6662, Feb. 21, 1974; 39 FR 26423, July 19, 1974]