[Code of Federal Regulations]
[Title 47, Volume 1]
[Revised as of October 1, 2007]
From the U.S. Government Printing Office via GPO Access
[CITE: 47CFR2.933]

[Page 643]
 
                       TITLE 47--TELECOMMUNICATION
 
              CHAPTER I--FEDERAL COMMUNICATIONS COMMISSION
 
PART 2_FREQUENCY ALLOCATIONS AND RADIO TREATY MATTERS; GENERAL RULES AND 
 
              Subpart J_Equipment Authorization Procedures
 
Sec.  2.933  Change in identification of equipment.

    (a) A new application for equipment authorization shall be filed 
whenever there is a change in the FCC Identifier for the equipment with 
or without a change in design, circuitry or construction. However, a 
change in the model/type number or trade name performed in accordance 
with the provisions in Sec.  2.924 of this chapter is not considered to 
be a change in identification and does not require additional 
authorization from the Commission.
    (b) An application filed pursuant to paragraph (a) of this section 
where no change in design, circuitry or construction is involved, need 
not be accompanied by a resubmission of equipment or measurement or test 
data customarily required with a new application, unless specifically 
requested by the Commission. In lieu thereof, the applicant shall attach 
a statement setting out:
    (1) The original identification used on the equipment prior to the 
change in identification.
    (2) The date of the original grant of the equipment authorization.
    (3) How the equipment bearing the modified identification differs 
from the original equipment.
    (4) Whether the original test results continue to be representative 
of and applicable to the equipment bearing the changed identification.
    (5) The photographs required by Sec.  2.1033(b)(7) or Sec.  
2.1033(c)(12) showing the exterior appearance of the equipment, 
including the operating controls available to the user and the 
identification label. Photographs of the construction, the component 
placement on the chassis, and the chassis assembly are not required to 
be submitted unless specifically requested by the Commission.
    (c) If the change in the FCC Identifier also involves a change in 
design or circuitry which falls outside the purview of a permissive 
change described in Sec.  2.1043, a complete application shall be filed 
pursuant to Sec.  2.911.

[63 FR 36598, July 7, 1998]